Filter
Top Products
Travelstar 5K160 (SATA) Hard Disk Drive Specification
98/167
14.16 Read Log Ext(2Fh)
Command Block Output Registers Command Block Input Registers
Register 7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0
Data Low - - - - - - - - Data Low - - - - - - - -
Data High - - - - - - - - Data High - - - - - - - -
Current - - - - - - - - Error ...See Below... Feature
Previous - - - - - - - -
Current V V V V V V V V HOB=0 - - - - - - - -Sector Count
Previous V V V V V V V V
Sector Count
HOB=1 - - - - - - - -
Current V V V V V V V V HOB=0 - - - - - - - -LBA Low
Previous - - - - - - - -
LBA Low
HOB=1 - - - - - - - -
Current V V V V V V V V HOB=0 - - - - - - - -LBA Mid
Previous V V V V V V V V
LBA Mid
HOB=1 - - - - - - - -
Current - - - - - - - - HOB=0 - - - - - - - -LBA High
Previous - - - - - - - -
LBA High
HOB=1 - - - - - - - -
Device - - - - ---- Device - - - - - - - -
Command 0 0 1 0 1 1 1 1 Status ...See Below...
Error Register Status Register
7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0
CRC UNC 0 IDN 0 ABT T0N AMN BSY RDY DF DSC DRQ COR IDX ERR
V V 0 V 0 V 0 0 0 V 0 V - 0 0 V
Figure 49 Read Log Ext Command (2Fh)
This command returns the specified log to the host. The device shall interrupt for each DRQ block
transferred.
Output Parameters To The Device
R
Phy Event Counter Reset bit. When Log address is 11h (Phy Event Counter) and this
bit is set to 1, all Phy Event Counter values are reset to 0 after sending the current
counter valules.
Sector Count Current
The number of sectors to be read from the specified log low order, bits (7:0). The log
transferred by the drive shall start at the sector in the specified log at the specified
offset, regardless of the sector count requested.
Sector Count Previous
The number of sectors to be read from the specified log high orders, bits (15:8).
LBA Low Current
The log to be returned as described in table 50.
LBA Mid Current
The first sector of the log to be read low order, bits (7:0).
LBA Mid Previous
The first sector of the log to be read high order, bits (15:8).
Log
address
Content Feature set Type
00h Log directory N/A Read Only
03h Extended Comprehensive SMART
error log
SMART error
logging
Read Only
07h Extended SMART self-test log SMART self-test Read Only
10h Command Error Native Command
Queuing
Read Only
11h Phy Event Counter Phy Event Counter Read Only
80h-9Fh Host vendor specific SMART Read/Wri
te
Figure 50 Log address definition