Filter
Top Products
1 - 6
Reading Techniques
The scanner has a view finder that projects a bright red aiming beam that corre-
sponds to its horizontal field of view. The aiming line should be centered hori-
zontally over the bar code; it will not read if the aiming line is in any other
direction.
The best focus point for reading most code densities is about 5 inches (12.7
cm) from the unit. To read single or multiple symbols (on a page or on an
object), hold the imager at an appropriate distance from the target, pull the trig
-
ger, and center the aiming line on the symbol.
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your scanner, or you’ve
changed some options and want the factory settings restored, scan the
Stan-
dard Product Default Settings
bar code below.
The Menu Commands starting on page 11-5 lists the factory default settings for
each of the commands (indicated by an asterisk (*) on the programming pages).
Plug and Play
Plug and Play bar codes provide instant scanner set up for commonly used
interfaces.
Note: After you scan one of the codes, power cycle the host terminal to have
the interface in effect.
Good Read
Bad Read
Bad Read
Standard Product Default Settings