Filter
Top Products
24
Operation
Audible Indicators
When the 7600 scanner is in operation, it provides audible feedback. These
sounds indicate the status of the scanner. Eight settings are available for the
tone of the beep (normal, 6 alternate tones and no tone) plus three volume
settings. To change the tone or volume, refer to Changing the Beeper Tone &
Volume on page 27.
One Beep
When the scanner first receives power, the amber LED will turn on,
the red LED will flash and the scanner will beep once. (The red
LED will remain on for the duration of the beep.) The scanner is
now ready to scan.
When the scanner successfully reads a bar code, the red LED will
flash and the scanner will beep once (if programmed to do so). If
the scanner does not beep once and the red light does not flash,
then the bar code has not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes page 26.
Three Beeps - During Operation
When placing the scanner in program mode, the red LED will flash
while the scanner simultaneously beeps three times. The red and
amber LEDs will continue to flash until the unit exits program mode.
Upon exiting program mode, the scanner will beep three times and
the red LED will stop flashing.
When configured, 3 beeps can also indicate a communications
timeout during normal scanning mode.
When using one-code-programming, the scanner will beep three
times (the current selected tone), followed by a short pause, a high
tone and a low tone. This tells the user that the single configuration
bar code has successfully configured the scanner.
Three Beeps - On Power Up
This is a failure indicator. Refer to failure modes page 26.