Filter
Top Products
Command Set Lists
C-4
show interface configuration
I
Show interface
configuration status
switch(config)#interface fastEthernet 2
switch(config-if)#show interface
configuration
show interface status
I
Show interface actual
status
switch(config)#interface fastEthernet 2
switch(config-if)#show interface status
show interface accounting
I
Show interface statistic
counter
switch(config)#interface fastEthernet 2
switch(config-if)#show interface
accounting
no accounting
I
Clear interface
accounting information
switch(config)#interface fastEthernet 2
switch(config-if)#no accounting
C-4 Trunk Commands Set
Commands
Level
Description Example
aggregator priority
[1~65535]
G
Set port group system
priority
switch(config)#aggregator priority 22
aggregator activityport
[Group ID]
[Port Numbers]
G
Set activity port switch(config)#aggregator activityport
2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G
Assign a trunk group with
LACP active.
[GroupID]: 1~3
[Port-list]: Member port
list. This parameter could
be a port range (ex.1-4) or
a port list separate by a
comma (ex.2, 3, 6)
[Workport]: The amount of
work ports. This value
could not be less than
zero or be large than the
amount of member ports.
switch(config)#aggregator group 1 1-4
lacp workp 2 or
switch(config)#aggregator group 2
1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk
group.
[GroupID]:1~3
[Port-list]: Member port
list. This parameter could
be a port range (ex.1-4) or
a port list separate by a
comma ex.2, 3, 6)
switch(config)#aggregator group 1 2-4
nolacp or
switch(config)#aggregator group 1
3,1,2 nolacp
show aggregator
P
Show the information of
trunk group
switch#show aggregator 1 or
switch#show aggregator 2 or
switch#show aggregator 3
no aggregator lacp
[GroupID]
G
Disable the LACP
function of trunk group
switch(config)#no aggreator lacp 1
no aggregator group
[GroupID]
G
Remove a trunk group switch(config)#no aggreator group 2
C-5 VLAN Commands Set
Commands Level Description Example