Filter
Top Products
Adjusting Power Saver
106
Administrative support
Adjusting Power Saver
To adjust the Power Saver setting:
1 Make sure the printer is on and Ready appears on the display.
2 Press on the operator panel.
3 Press until Settings appears, and then press .
4 Press until Setup Menu appears, and then press .
5 Press until Power Saver appears, and then press .
6 Using the numeric pad or the right and left arrows on the operator panel, enter the number of minutes for the
printer to wait before entering Power Saver.
The settings available range from 2–240 minutes. If you want to turn Power Saver off, see Disabling Power Saver
on page 106.
7 Press .
Submitting Selection appears.
Note: You can also adjust the Power Saver setting by issuing a Printer Job Language (PJL) command.
Disabling Power Saver
Disabling Power Saver is a two step process. First, you must turn the variable on, and then select the variable. To disable
Power Saver:
1 Turn the printer off.
2 Press and hold and while turning the printer on.
3 Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4 Press until Energy Conserve appears, and then press .
5 Press until Off appears, and then press .
Submitting Selection appears.
The operator panel returns to Energy Conserve.
6 Press until Exit Config Menus appears, and then press .
Resetting the Printer appears briefly followed by a clock. The operator panel then returns to Ready.
7 Make sure Ready appears.
8 Press on the operator panel.
9 Press until Settings appears, and then press .
10 Press until Setup Menu appears, and then press .
11 Press until Power Saver appears, and then press .
12 Use either the numeric keypad or the right and left arrows to enter 0 (zero). Disabled appears, and then press
.
Submitting Selection appears. Power Saver is now disabled.