Filter
Top Products
9. Select OK when you have finished selecting and editing protocols in the MPTS
Configuration panel.
10. Select Close on the Configure panel.
11. Select Exit in the MPTS dialog box.
12. Select Exit on the Update CONFIG.SYS panel to update the CONFIG.SYS
file.
13. Select OK when you get the message that the CONFIG.SYS has been
successfully updated.
14. Select Exit on the Exiting MPTS panel.
15. Shut down and restart the computer to apply the changes.
16. At system startup, check for the following conditions to determine whether the
adapter is working correctly and whether installation has been completed
successfully:
v The device driver files loaded successfully. There are no error messages.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
For information concerning NDIS driver error messages, see “Appendix C. NDIS 2
device driver messages” on page 59.
OS/2 NDIS 2 device driver using other installation programs
Use the following procedure to install the OS/2 NDIS 2 device driver using
installation programs other than MPTS.
1. Insert the CD-ROM or the NDIS Drivers diskette into the appropriate drive.
2. Use your product documentation to install the driver (IBMTRP.OS2) that is
located in the root directory on both the CD-ROM and diskette.
3. Modify the parameters if needed. See “Appendix B. NDIS 2 device driver
parameters” on page 53 for a list and explanation of parameters.
IBM TCP/IP for OS/2 and Warp Connect are examples of products that provide
driver installation programs.
4. Shut down and restart the computer to apply the changes.
5. Check for the following conditions to determine whether the adapter is working
correctly and whether installation has been completed successfully:
v The device driver files load successfully. There are no error messages.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
For information concerning NDIS driver error messages, see “Appendix C. NDIS 2
device driver messages” on page 59.
OS/2 Novell NetWare Requester
Before installation, copy IBMTRPO.SYS from the CD-ROM to the root directory
containing your Novell NetWare Requester source files.
Refer to the workstation basics and installation manuals from Novell. When a dialog
box titled Requester Installation appears during the installation process, perform the
following procedure:
20 IBM 16/4 Token-Ring PCI Management Adapter