Filter
Top Products
Windows has finished installing an updated driver for your hardware
device.
Select Finish to continue.
12. Select Yes when asked to reboot the system.
13. Check for the following conditions to determine whether the adapter is working
correctly and whether installation has been completed successfully:
v The device driver files loaded successfully.
v The Local Area Connection icon shows that the device is working correctly.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
Updating the driver when Windows 2000 is already installed
This procedure assumes that both Windows 2000 and the adapter are already
installed on your computer.
When Windows 2000 boots, it will detect the new hardware and attempt to install a
driver. Use the following procedure to install the driver that came with your adapter.
1. A Digital Signature Not Found window might appear saying that the driver is not
digitally signed. If so, select Yes to continue.
2. An Insert Disk dialog box appears, prompting you to insert a diskette containing
the driver. Insert the diskette and select OK to continue.
Note: If you are installing from the CD-ROM, specify the CD-ROM drive letter,
for example x:\ after you select OK.
3. Windows 2000 installs the driver and returns you to the desktop when finished.
4. Check for the following conditions to determine whether the adapter is working
correctly and whether installation has been completed successfully:
v The device driver files loaded successfully.
v The Local Area Connection icon shows that the device is working correctly.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
Remote unattended installation of Windows 95, Windows 98, Windows
2000, and Windows NT
Instructions for this environment are on the adapter CD-ROM. You can read the
instructions with a Web browser. To access the instructions, perform the following
steps:
1. Go to x:\startcd.htm (where x is your CD-ROM drive).
2. Select the proper adapter and then select Downloads.
3. Select the proper operating system to expand the list of packages.
4. Select Remote Unattended Install (RUI).
Novell IntranetWare Client for Windows NT
1. If the NDIS driver is not already installed, follow the instructions in “Windows NT
Version 4.0” on page 24 or “Windows NT Version 3.51” on page 23. At step 11
of those instructions, make sure that you select the appropriate protocols and
services to connect to the network.
32 IBM 16/4 Token-Ring PCI Management Adapter