Filter
Top Products
Note: If you use Microsoft Windows for Workgroups and want to configure the
NetAddress parameter for the NDIS device driver, remember to enclose
the address in double quotes (" "). The NetAddress parameter is used to
set a locally administered address for the adapter.
4. Shut down and restart the computer to apply the changes.
5. Check for the following conditions to determine whether the adapter is working
correctly and whether installation has been completed successfully:
v The device driver files load successfully. There are no error messages. If
error messages are displayed or if you do not see messages that indicate
that the drivers have been installed, see “Starting the troubleshooting
process” on page 37.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
For information concerning NDIS driver error messages, see “Appendix C. NDIS 2
device driver messages” on page 59.
DOS Novell NetWare Requester (16-bit)
The 16-bit DOS Novell NetWare Requester environment supports access to servers
running Novell NetWare 3.11 or later.
To install the IBMTRPO.EXE ODI driver on a computer running DOS, perform the
following procedure:
Note: Consult your Novell NetWare documentation for instructions regarding how to
create the NetWare Client for DOS and MS Windows diskettes.
1. Create a diskette containing the extracted files from the DOSODIP.EXE file on
the adapter CD-ROM.
2. Insert the NetWare Client for DOS and MS Windows Disk 1 into the
appropriate drive.
3. At the command prompt, type x:, where x is your drive letter, and then press
Enter.
4. Type install and then press Enter.
5. Follow the instructions as they appear. In step 5 of those instructions, select
the driver for your network board by scrolling down through Network Boards,
highlighting Other Drivers, and pressing Enter.
6. Insert the CD-ROM or the diskette that you created in step 1 of this procedure
into the appropriate drive. When prompted, specify the location to the chosen
media and press Enter. Specify the path as A:\NOVELL\DOS (or at
X:NOVELL\DOS for the CD-ROM version).
7. Highlight your adapter and press Enter.
8. At this time you can change the default parameters. When you complete the
changes, press F10. “Appendix F. Novell NetWare DOS ODI driver parameters”
on page 77 contains the parameters that can be configured in the NET.CFG
file.
9. Follow the instructions presented to complete the installation.
Note: If source routing is required, edit the STARTNET.BAT file that is in the
client directory (usually C:\NWCLIENT) and add the following line after
the IPXODI statement:
22 IBM 16/4 Token-Ring PCI Management Adapter