Filter
Top Products
Replacing the Battery
To replace the battery:
1. Locate the battery on the system board (see “System Board Illustration” on
page 168).
2. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery toward the front of the server.
The spring mechanism behind the battery will push it out toward you as you
slide it forward.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
3. Insert the new battery:
a. Tilt the battery so that you can insert it into the front of the socket, under
the battery clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
4. Reinstall the server covers and complete the installation (see “Completing the
Installation” on page 76).
5. Start the Configuration/Setup Utility program and reset configuration parameters
as needed.
To reset the system date and time, go to “Date and Time” on page 24.
To reset the power-on password, go to “Using the Power-on Password
Menu” on page 25.
To reconfigure your system, follow the instructions given in “The
Configuration/Setup Utility” on page 21 (all models).
160 Netfinity 5000 Server Hardware Information and Procedures