Filter
Top Products
1
DANGER
To avoid a shock hazard, do not connect or disconnect any
cables or perform installation, maintenance, or reconfiguration
of this product during an electrical storm.
To avoid shock hazard:
– The power cord must be connected to a properly wired and
earthed receptacle.
– Any equipment to which this product will be attached must
also be connected to properly wired receptacles.
When possible, use one hand to connect or disconnect signal
cables to prevent a possible shock from touching two surfaces
with different electrical potentials.
Electrical current from power, telephone, and communications
cables is hazardous. To avoid shock hazard, connect and
disconnect cables as described following when installing,
moving, or opening covers of this product or attached devices.
To Connect
1. Turn Everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to receptacles.
4. Attach power cord(s) to outlet.
5. Turn device ON.
To Disconnect
1. Turn Everything OFF.
2. First, remove power cord(s) from
outlet.
3. Remove signal cables from
receptacles.
4. Remove all cables from devices.
NOTE: In the UK, by law, the telephone
cable must be connected after the power
cord.
NOTE: In the UK, the power cord must be
disconnected after the telephone cable.
viii Netfinity 5000 Server Hardware Information and Procedures