Filter
Top Products
Completing the Installation
Completing the Installation
Before you begin
Complete all the installation procedures for the internal options you have
chosen to install.
Read “Electrical Safety” on page 41.
If you have a tower model, continue with “Completing the Tower Model
Installation.”
If you have a rack model, go to “Completing the Rack Model Installation” on
page 79.
Completing the Tower Model Installation
1. Install the cover on the server.
a. Align the left-side cover with the left side of the server, about 25 mm (1
inch) from the front of the server; place the bottom of the left-side cover on
the bottom rail of the left-side frame.
b. Insert the tabs at the top of the cover into the slots at the top of the server
side.
c. Hold the cover against the server and slide the cover toward the front of
the server until the cover clicks into place.
Note: Be sure the front edge of the cover is flat against the server.
76 Netfinity 5000 Server Hardware Information and Procedures