Filter
Top Products
Netcool/Precision for Transmission Networks 5.5 Administration Guide14
Running the installation in GUI mode
To install Netcool/Precision TN on your system:
1. From a command prompt, change to the directory where you extracted the contents of
the Netcool/Precision TN tar file.
2. Run the installation by entering:
./INSTALL
Running this command with no arguments sets the installation log file level to a
default of warning messages only. If you want to set the level of detail in the
installation log file for information or troubleshooting purposes, enter the following
command instead:
./INSTALL -errorlevel ERRORLEVEL
Where ERRORLEVEL takes one of three values:
– debug - Detailed logging for debug purposes
– info - Warning and information notices
– warning - Warning messages only
You will be presented with the Welcome window (Figure 4.) Click Next to proceed.
Figure 4. Netcool Installer Welcome window