Filter
Top Products
SERIAL INTERFACE DEVELOPERS GUIDE
/* Calibration and Defect Communication Status Enumerations */
enum
{
HOST_READY = 0xFFFF,
BEGIN_PROCESS = 0,
CAL_PLACE_COLD_REF,
CAL_COLD_REF_IN_PLACE,
CAL_PLACE_HOT_REF,
CAL_HOT_REF_IN_PLACE,
CAL_DELTA_TOO_SMALL,
CAL_COMPLETED,
CAL_CALC_COEFFICIENTS,
DEFECT_TOO_MANY,
DEFECT_ERASE_FLASH,
DEFECT_ERASE_ACK,
DEFECT_COMPLETED,
UNIFORMITY_TEST_IN_PROGRESS,
NUC_FLASH_PROGRAMMED,
HOST_UNDEFINED
};
7.1 One Point Refresh Calibration (Internal Flag):
(A) TSend TCMD_ONE_PT_REFRESHT command with argument for using internal calibration flag.
(B)
TEmbedded application will set the Tstatus code to BEGIN_PROCESS, and then begin execution of
the calibration.
T
(C) Host may monitor (periodically read) the status code data member until it is set by the embedded
application to CAL_COMPLETED.
(D) Calibration is complete
7.2 One Point Refresh Calibration (External Flag):
(A) Send CMD_ONE_PT_REFRESH command with argument for using external calibration flag.
(B) Embedded application will set the status code to BEGIN_PROCESS, and then begin execution of
the calibration.
(C) Host will monitor (periodically read) the status code data member until it is set by the embedded
application to CAL_PLACE_COLD_REF.
(D) Host/User automatically or manually places the cold reference in the sensor field of view.
(E) Host application sets the status code to CAL_COLD_REF_IN_PLACE.
(F) Host will monitor the status code data member until it is set by the embedded application to
CAL_CALC_COEFFICIENTS or CAL_COMPLETED.
(G) The host/user may now remove the cold reference if desired.
(H) Calibration is complete
7.3 One Point Update Calibration (Internal Flag):
(A) Send CMD_ONE_PT_UPDATE command with argument for using internal calibration flag.
(B) Embedded application will set the status code to BEGIN_PROCESS, and then begin execution of
the calibration.
(C) Host will monitor (periodically read) the status code data member until it is set by the embedded
application to CAL_COMPLETED.
(D) Read the “CameraConfig.camStats.HostData” member to retrieve number of defects if desired.
39