Filter
Top Products
SERIAL INTERFACE DEVELOPERS GUIDE
1 – Enable Temperature Excursion Based 1-Pt Refresh
Rfsh On Boot 0 – Disable 1-Pt Refresh on Bootup;
1 – Enable 1-Pt Refresh on Bootup (Camera waits until FPA Temperature Stable)
Rfsh On Sw 0 – Disable 1-Pt Refresh on NUC Switch;
1 – Enable 1-Pt Refresh on NUC Switch
Zn Stat En 0 – Disable Zone Statistics Computation;
1 – Enable Zone Statistics Computation
Rtcl A En 0 – Disable Reticle A Overlay;
1 – Enable Reticle A Overlay
Rtcl B En 0 – Disable Reticle B Overlay;
1 – Enable Reticle B Overlay
FPA Processor User Mode Control:
Non-Volatile Copy of FPA Processor User Mode Control Register.
Used to Restore FPA Processor Register on Power On Reset.
Active Operational Mode:
Selects the Currently Active Op Mode (0 <= Act Op Mod <= 15).
Use the Appropriate Op Mode Descriptor Table Values to Load the FPA Processor Registers.
Active NUC Index:
Selects the Currently Active NUC Index (0 <= Act Nuc Indx <= 63).
Use the Appropriate NUC Mode Descriptor Table Values to Load the FPA Processor Registers.
Limit the NUC Index to the Range Defined by the Current Active Operational Mode.
Auto NUC Switch Parameters:
If Auto Nuc Sw = 1, then Decrement the NUC Index by 1 if the Number of FPA Pixels that are Less
than the Auto NUC Switch Low Saturation Intensity Threshold is Greater than the Auto NUC Switch
Low Saturation Count Threshold. Likewise, Increment the NUC Index by 1 if the Number of FPA
Pixels that are Greater than the Auto NUC Switch High Saturation Intensity Threshold is Greater
than the Auto NUC Switch High Saturation Count Threshold. In Any Case, Limit the NUC Index to
the Range Defined by the Current Active Operational Mode.
52