Filter
Top Products
Table 6. 3130 Power Dissipation
Mode Power Usage
Printing 900 watts
Standby 220 watts
Power Saving 100 watts
Physical Requirements
Weight and Dimensions
The standard simplex model O3S weighs 154 kg (337 lb); the standard duplex
model O2D weighs 156 kg (343 lb).
The dimensions of the 3130 are:
Standard Paper Handling Fully Featured Paper
Handling
Width 654 mm (26 in.) 1353 mm (53 in.)
Depth 640 mm (26 in.) 640 mm (26 in.)
Height 1385 mm (54 in.) 1385 mm (54 in.)
Service Clearances
The service clearances required for the 3130 are:
Front 1295 mm (51 in.)
Rear 910 mm (36 in.)
Left 760 mm (30 in.)
Right 760 mm (30 in.)
Physical Layout and Space Requirements
Figure 1 on page 22 shows the space requirements for a permanent installation.
As you plan your physical layout:
Install the 3130 away from the main traffic pattern. Allow space for key
operators and customer engineers to perform their tasks. This space should
not extend into walkways.
Install the 3130 in a location that is convenient for the key operator and other
users. For example, consider whether the planned location is close to printer
supply storage areas and to output distribution areas.
Allow 2.1 meters (83 in.) between the floor and the lowest permanently
attached object above the 3130, such as a light or a cable rail. This layout
gives printer operators and customer engineers space in which to work.
Check the route that the 3130 must travel from your loading dock to the
location where it will be installed, to make sure it fits through the doorways and
halls. When possible, move the printer from the dock to its installation location
on its shipping pallet.
Chapter 4. Preparing the Physical Environment 21