Filter
Top Products
Starting TCP/IP Interfaces
TCP/IP interfaces are started in one of the following ways:
v The Work with TCP/IP Interface Status displays are reached by:
– Option 1 on the Configure TCP/IP (CFGTCP) menu
– Option 1 on the Network Status (NETSTAT or WRKTCPSTS) menu
v The Start TCP/IP Interface (STRTCPIFC) command
v Using the Operations Navigator interface
Note: You can start TCP/IP interfaces through the Operations Navigator
interface wizard. However, this chapter does not document any of the
Operations Navigator functions. See the online help in Operations
Navigator for this information.
To start a TCP/IP interface from the Work with TCP/IP Interface Status menu,
type 9 in the option field for each interface that you want to start and press the
Enter key.
To start a TCP/IP interface using the STRTCPIFC command, take these steps:
1. Type STRTCPIFC on the command line and press F4 (Prompt).
2. Type the Internet address of the interface that you want to start and press the
Enter key.
Option 9 on the Work with TCP/IP Interface Status display is used to start both
TCP/IP interfaces and Internet Protocol (IP) over Systems Network Architecture
(SNA) interfaces. For information about starting IP over SNA interfaces, see the
STRIPSIFC (Start IP over SNA Interface) command in Control Languages
(http://publib.boulder.ibm.com/pubs/html/as400/v5r1/ic2924/info/rbam6/
rbam6clmain.htm) in the Information Center. If you are using the Supplemental
Manuals CD, then switch to the iSeries Information Center CD to access this
information.
Note: When starting the first TCP/IP interface associated with an Integrated
xSeries Server for iSeries (also known as File Server Input/Output Processor
and FSIOP) network server description, a considerable amount of time may
pass before the interface becomes active. This is because TCP/IP activation
includes starting the network server. The amount of time that is required
Work with TCP/IP Interface Status
System: SYSNAM04
Type options, press Enter.
5=Display details 8=Display associated routes 9=Start 10=End
12=Work with configuration status
Internet Subnet Type of Line
Opt Address Mask Service MTU Type
9.125.87.10 255.255.255.0 *MAXTHRPUT 1989 *TRLAN
9.125.87.222 255.255.255.0 *NORMAL 1989 *TRLAN
127.0.0.1 255.0.0.0 *NORMAL 576 *NONE
Figure 26. Work with TCP/IP Interface Status, Display 2 of 2
Chapter 2. TCP/IP: Operation, Management, and Advanced Topics 35