Filter
Top Products
Heater-specific diagnosis Menu: View
15
2.3. Menu: View
You can select between different views in order to see different displays
and data about the heaters:
2.3.1. Overview window
This view gives you an overview on the values during the diagnosis.
In addition to the operating voltage, temperature, etc. the device status
is also shown.
• Use the View/Overview window… menu command or click the
button to open the Overview window.
2.3.2. Operating data
The operating data view gives you an overview of a number of parame-
ters in addition to the values that have been found and the units for them.
• Use the View/Operating data… menu command or click the
button to open the Operating data.
2.3.3. Control unit information
The device information view contains a list of all the information and
values relating to the connected device.
• Use the View/Control unit information… menu command or click the
button to open the Control unit information.
2.3.4. Trend graphic
The graphical trend view shows the sequence of the heater values over
time in a diagram. Right-clicking the display with the mouse displays a
shortcut menu for the displayed values. You can show or hide the
individual values by clicking here. The same thing applies to the displays
in point 7.5 Protocol display.
• Use the View/Trend graphic… menu command or click the button
to open the Trend graphic.
2.3.5. Protocol display
This protocol display view lists all the statuses of the heater during the
diagnosis.
• Open the last of the five views of the diagnostic results using menu
command View/Protocol display… or by clicking the button .
• To close this view click the square at the far right of the window title
bar.
101493_PCTe_gb.book Seite 15 Donnerstag, 16. Juni 2005 11:47 11