Filter
Top Products
General information/installation Diagnostic-capable units
5
1.3. Diagnostic-capable units
Heater selection for USB interface
NOTE
If the device is not listed in Select device, the heater must be a model
with W-Bus. W-Bus-capable heaters are grouped under the heading
of W-Bus. In this case use the W-Bus selection. The W-Bus selection
contains a list of various heaters that use the same diagnostic port
(see also point 1).
Heater selection for COM interface
Diagnosis of the following units is only possible via serial port, the USB
interface cannot be used with these units:
Thermo 50; Thermo 90;
Thermo 230; Thermo 300; Thermo 350 (not with SG1572 K-line)
BBW 46S; BW 80; DBW 46S; DW 80; DW 230; DW 300; DW 350
101493_PCTe_gb.book Seite 5 Donnerstag, 16. Juni 2005 11:47 11