Filter
Top Products
Advanced/ZP Technical Product Summary • Page 27
Typematic Rate
When selected, this brings up a dialog box that allows you to set the speed at which characters repeat when you hold
down a key on the keyboard. The higher the number, the faster the characters repeat. The options are 6, 8, 10, 12, 15,
20, 24, and 30 characters per second. The default is 6. If Typematic Rate Programming is set to Default, this option
will not be visible.
ADVANCED SCREEN
This section describes the Setup options found on the Advanced menu screen. If you select certain options from the
Advanced screen (e.g, Peripheral Configuration), the Setup program will switch to a submenu for the selected option.
Submenus are described in the sections following the description of the Advanced screen options.
Processor Type
This reports the CPU type. This is informational only, and there are no options.
Processor Speed
This reports the clock speed of the CPU. This is informational only, and there are no options.
Cache Size
This reports the size of the secondary cache. This is informational only, and there are no options. If no secondary cache
is installed, this field will not be displayed.
Peripheral Configuration
When selected, this brings up the Peripheral Configuration submenu.
Advanced Chipset Configuration
When selected, this brings up the Advanced Chipset Configuration submenu.
Power Management Configuration
When selected and enabled, this brings up the Advanced Power Management (APM) submenu.
Plug and Play Configuration
When selected, this brings up the Plug and Play Configuration submenu.
PERIPHERAL CONFIGURATION SUBMENU
Configuration Mode
When selected, this brings up a dialog box that allows you to set the peripheral configuration yourself, or have the
system do it. The options are Auto and Manual. The default is Auto.
When Auto is selected, the system peripherals are automatically configured during power up. The options below for the
PCI/IDE Interfaces, Floppy Interface, Serial Port 1 and Serial Port 2 Addresses, and the Parallel Port Address can not
be modified. The settings displayed for those options reflect the current state of the hardware, and not necessarily the
state after reboot.
If Manual is selected, the options for the PCI IDE Interfaces, Floppy Interface, Serial Port 1 and Serial Port 2
Addresses, and Parallel Port Address can be explicitly configured.