Filter
Top Products
2
14
Hardware Installation
Note:
1. Intel Celeron
TM
processors support VID (Voltage Identification).
The switching voltage regulator on the system board will
automatically set the voltage regulator according to the
voltage of the processor.
2. You cannot overclock an Intel Celeron
TM
processor because its
frequency ratio is fixed by the manufacturer. The table above
is for factory use only.
2.4 Jumper Settings for the CPUs Front Side Bus
Jumper JP2
CPUs Front Side Bus Select
The default setting of jumper JP2 is
Auto - the system will automatically
run according to the FSB of the
processor. The 100MHz setting
(1-2-3 Off) is reserved for future
100MHz FSB processors. Refer to
the figure on the next page.
Warning:
If your system is installed with
a 66MHz FSB processor, do
not move the jumper cap from
its default setting which is pins
1 and 2 On; otherwise your
system will not boot.
300MHz
4.5x
333MHz
5x
Processor
SW1
66MHz
100MHz
Frequency
Ratio
Future
processor
5.5x
Processor
SW1
66MHz 100MHz
Frequency
Ratio
400MHz
Future
processor
433MHz
Future
processor
Future
processor
Future
processor
Future
processor
Future
processor
6x
6.5x
7x
7.5x
8x
Future
processor
Future
processor
366MHz
Future
processor
Future
processor