Filter
Top Products
40
3
Award BIOS Setup Utility
Soft-Off by PWR-BTTN
This category allows you to select the method of powering off your
system.
Hold 4 Sec. Regardless of whether the Power Management field is
enabled or disabled, if the power button is pushed
and released in less than 4 sec, the system enters the
Suspend mode. The purpose of this function is to
prevent the system from powering off in case you
accidentally hit or pushed the power button. Push
and release again in less than 4 sec to restore.
Pushing the power button for more than 4 seconds
will power off the system.
Instant-Off Pressing and then releasing the power button at
once will immediately power off your system.
PWR Lost Resume State
Keep Off When power returns after an AC power failure, you
must press the Power button to power-on the system.
Turn On When power returns after an AC power failure, the
system will automatically power-on.
Last State When power returns after an AC power failure, the
operating session where you left off before power
failure occurs will resume.
Resume On Ring
With an external modem installed, the Modem Ring-on function will
allow your system to power-on to respond to incoming calls. By
default, the Resume on Ring field is Disabled. To use this function,
please follow the steps below.
1. Make sure the computer system is powered off.
2. Connect the external modem to the COM 1 or COM 2 serial
port.
3. Switch on the power of the external modem.
4. Power-on the computer system. After the memory test, press
<Del> to enter the Award BIOS setup utility.
5. Select Power Management Setup and press <Enter>.
6. Enable the Resume on Ring field.