Filter
Top Products
Intel
®
NetStructure™ MPRTM4808 Rear Transition Board Installation Guide 13
Installation
Note: CompactFlash disks of types I and II are supported.
3.3.1.3 Installation Procedure
Note: To configure the card to the supported true-IDE mode, the card must already be inserted when the
board’s power is turned on. Inserting the CompactFlash while the board’s power is still on will
configure the CompactFlash disk to PC Card ATA mode, which is not supported by the CPU board.
If you have inserted the card while the board’s power has been turned on, remove the card and
reinsert it with the board’s power turned off.
1. Consult system documentation and perform any steps required before turning off CPU power.
2. Turn off CPU power.
3. Check that disk’s connectors face CompactFlash socket.
4. Plug the CompactFlash disk into socket. The CompactFlash disk is connected to the socket if
the ejector pin on the front panel is pushed out of the recess.
5. Turn on CPU power.
Figure 4. Location of CompactFlash Slot
Figure 5. Inserting a CompactFlash Disk into Socket
T
M
C
O
M
P
A
C
T
F
L
A
S
H