Filter
Top Products
PX865PEL-800
18
Chapter 2. BIOS Setup
Introduction
This section describes PHOENIX-AWARD™ BIOS Setup program. The Setup program allows users
to modify the basic system configuration. The configuration information is then saved to CMOS
RAM where the data is sustained by battery after power-down.
The BIOS provides critical low-level support for standard devices such as disk drives, serial ports
and parallel ports. As well, the BIOS controls the first stage of the boot process, loading and
executing the operating system.
The PHOENIX-AWARD
TM
BIOS installed in your computer system’s ROM is a custom version of
an industry standard BIOS. This means that it supports the BIOS of Intel
®
based processors.
This version of the PHOENIX-AWARD
TM
BIOS includes additional features such as virus and
password protection as well as special configurations for fine-tuning the system chipset. The defaults
for the BIOS values contained in this document may vary slightly with the version installed in your
system.
Plug and Play Support
This PHOENIX-AWARD™ BIOS supports the Plug and Play Version 1.0A specification as well as
ESCD (Extended System Configuration Data) write.
EPA Green PC Support
This PHOENIX-AWARD™ BIOS supports Version 1.03 of the EPA Green PC specification.
APM Support
This PHOENIX-AWARD™ BIOS supports Version 1.1 & 1.2 of the Advanced Power Management
(APM) specification. These features include system sleep and suspend modes in addition to hard disk
and monitor sleep modes. Power management features are implemented using the System
Management Interrupt (SMI).
PCI Bus Support
This PHOENIX-AWARD™ BIOS also supports Version 2.3 of the Intel PCI (Peripheral Component
Interconnect) local bus specification.
DRAM Support
DDR (Double Data Rate) SDRAM (Synchronous DRAM) is supported.