Filter
Top Products
PX865PEL-800
32
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on your
system. This filed is only configurable when “Power On Function” is set to “Hot Key”.
Options: Ctrl-F1、Ctrl-F2…… Ctrl-F12
Onboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”.
Options: Enabled (default)、Disabled
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、
2E8/IRQ3、Auto
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)、ASKIR、IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if “UART Mode
Select” is set to “ASKIR” or “IrDA”.
Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo
IR Transmission Delay
This item allows you to enable/disable IR transmission delay. This field only configurable if “UART
Mode Select” is set to “ASKIR” or “IrDA”.
Options: Enabled (default)、Disabled
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options: Half (default)、Full