Filter
Top Products
Intel
®
Server System SR1550AL/SR1550ALSAS User’s Guide 47
11. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct”.
12. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
13. Plug all peripheral devices and the AC power cable into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Chassis
Cover”.
4. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct”.
5. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly”.
6. Open the rear retention clip by pushing the blue slide upward and rotating clip to
the fully open position (see letter “A”).
7. Remove the PCI add-in card from the riser card connector (see letter “B”).
Figure 40. Removing an Add-In Card
8. Close both retention clips.
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCI riser assembly into the server system. For instructions, see
“Installing the PCI Riser Assembly”.
10. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct”.
11. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
TP02241
A
B