66 Intel
®
Server System SR1550AL/SR1550ALSAS User’s Guide
Replacing the Power Distribution Module
To replace the power distribution module, use the following instructions.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Chassis
Cover”.
4. Remove the hot-swap power supply/supplies. For instructions, see “Replacing or
Adding a Power Supply”.
5. Remove the screw to release the power distribution board cover (see letter “A”).
6. Lift the power distribution board cover from the server system (see letter “B”).
Figure 57. Removing the Power Distribution Board Cover
7. Disconnect power from the system boards.
8. Remove the power distribution board by sliding the board to the right and lifting.
9. Install a new power distribution board by lining up the standoffs to the holes in the
power distribution board and sliding the board to the left.
10. Reconnect the power connections to the system boards.
A
B
TP02228