Intel
®
Server System SR1550AL/SR1550ALSAS User’s Guide 29
Installing the Processor Air Duct
1. Observe the safety and ESD precautions at the beginning of this book. See "“Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Chassis
Cover”.
4. Turn processor air duct over to reveal underside.
5. Installing a second processor: remove air dam by sliding slotted holes off duct pins.
Notes: Do not remove the air dam if only one processor is installed.
Do not remove memory air deflector.
Figure 22. Removing the Processor 2 Air Dam (Optional - only if two
processors are installed)
6. Place the processor air duct over the processor socket(s). See the figure below. The
front edge of the air duct should contact the fan module. Use caution not to pinch or
disengage cables that may be near or under the air duct.
7. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
8. Plug all peripheral devices and the AC power cable into the server.
Figure 23. Installing the Processor Air Duct
TP02227
TP02226