Filter
Top Products
Intel
®
Server System SR1550AL/SR1550ALSAS User’s Guide 39
Figure 33. Installing an Optical Drive Assembly into the Server System
10. Insert IDE ribbon cable through slot in fan module.
11. Plug cable ends into matching sockets on backplane and server board. Make sure
the cable does not restrict fan module air flow.
12. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
13. (Optional) Install the front bezel. For instructions, see “Removing and Installing the
Front Bezel”.
14. Plug all peripheral devices and the AC power cable into the server.
Removing a Slimline Optical Drive or Internal USB Floppy
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the front bezel if it is installed. For instructions, see “Removing the Front
Bezel”.
4. Remove the server system cover. For instructions, see “Removing the Chassis
Cover”.
5. Press the blue release lever (see letter “A”) to unlock the optical drive tray and
remove the slimline optical drive tray assembly from the server system as shown in
Figure 34.
TP02234