Filter
Top Products
38 Intel
®
Server System SR1550AL/SR1550ALSAS User’s Guide
Installing a Slimline Optical Drive or Internal USB Floppy
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the front bezel if it is installed. For instructions, see “Removing the Front
Bezel”.
4. Remove the server system cover. For instructions, see “Removing the Chassis
Cover”.
5. Install the interposer board to the rear of the optical drive as shown in the figure
below.
Figure 32. Installing the Interposer Board to the Optical Drive
6. Insert the optical drive tray assembly into the server system as shown in Figure 33.
7. Make sure that the back end of the interposer board plugs into the matching socket
on the backplane.
8. Verify that the blue release lever on the tray locks into place.
9. (Optional) For installing the optional USB floppy drive, note the location of the
backplane USB connector and refer to the documentation that came with the
device.
TP02233