Filter
Top Products
4.7 System Conguration
Double-click the System icon to display the System conguration screen, where
you can see all available printing protocols and upgrade the rmware.
Port Name: You can name the port the MFP server connects to. The default port
name is ‘’p1.’’
Upgrade Firmware: You can use this Upgrade Firmware tool to upload the
newest rmware for the MFP server. Click and select the correct rmware in
your PC. After selecting the rmware le, click “Upgrade” to nish the rmware
update process. NOTE: Before you upgrade the rmware, make sure the IP
address settings of the MFP server are in the same network as your computer.
Load Default: Click to reset the MFP server to default factory settings.
Wireless Function: Select “Auto,” “Enable” or “Disable” to manually congure the
wireless function.
• “Auto” is the default setting of the MFP server. In this mode, the MFP server
will automatically decide to enable or disable the wireless function. When the
MFP server starts up, it will auto-detect if the LAN port is connected to an
active network by an Ethernet cable. If this is the case, the MFP server will run
in Ethernet mode. If the MFP server is not connected to an active network by
an Ethernet cable, the MFP server will run in wireless LAN mode.
You can plug the Ethernet cable into the MFP server, then, after conguring
the MFP server features and wireless settings, unplug the Ethernet cable to
enable the wireless connection. This makes the conguration much easier
without creating the wireless connection in advance. NOTE: After setting the
wireless function, remove the Ethernet cable and then remove and re-connect
the power cable of the MFP server to activate the wireless connection.
23
SERVER CONFIGURATION