Filter
Top Products
TCP/IP Printing (LPR/IPP/RAW): The MFP server supports the TCP/IP network
protocol and LPR/IPP/RAW printing protocols. By default, these protocols are
enabled.
5.4.2 Wireless
If you want to use the MFP server through a wireless LAN, set up the MFP server
through Ethernet rst and make sure your wireless LAN setting is correct. After
setting the wireless LAN, unplug the Ethernet cable and restart the MFP server.
Then you can start to use the MFP server through the wireless LAN. If the
wireless conguration doesn’t work, plug in the Ethernet cable again, re-start the
MFP server and congure the MFP server through Ethernet until the wireless LAN
settings are correct.
You can enable/disable the wireless function and set up the wireless parameters
— including Function and ESSID — for the MFP server from here. You can
manually set the wireless network that you want to connect on this screen or use
the Site Survey screen to automatically search for an available wireless network
and associate with it.
Function: Allows you to disable, enable or let the MFP server auto-select to
connect to a wired or wireless network. If “Disable” is selected, the MFP server
can only connect to the network through wired Ethernet. If “Enable” is selected,
the MFP server can only connect to the network through a wireless LAN. If
“Auto” is selected, the MFP server can automatically decide to enable or disable
the wireless function.
The MFP server only can work in Ethernet or wireless LAN mode. It can’t work
in both Ethernet and wireless LAN mode at the same time. When the MFP
server starts up, it will auto-detect if the LAN port is connected to an active
network by an Ethernet cable. If the MFP server is connected to an active
network by Ethernet cable when starting up, the MFP server will run in Ethernet
mode. If the MFP server is not connected to an active network by Ethernet
cable when starting up, the MFP server will run in wireless LAN mode. The
MFP server default mode is “Auto.”
33
WEB MANAGEMENT