Filter
Top Products
frequency range to reduce the potential for harmful interference to co-channel
mobile satellite systems.
rss-210 ComplianCE statEmEnt
The term “IC:” before the certication/registration number only signies that
Industry Canada technical specications were met. Operation is subject to the
following two conditions: 1) This device may not cause interference; and 2) this
device must accept any interference, including interference that may cause
undesired operation of the device.
transmittEr antEnna
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not
more than that required for successful communication. This device has been
designed to operate with an antenna having a maximum gain of 5dBi. Antenna
having a higher gain is strictly prohibited per regulations of Industry Canada. The
required antenna impedance is 50 ohms.
iC radiation ExposurE statEmEnt
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20 cm between the radiator and your body. This device and
its antenna(s) must not be co-located or operated in conjunction with any other
antenna or transmitter.
r&ttE ComplianCE statEmEnt
This equipment complies with all the requirements of Directive 1999/5/EC of the
European Parliament and the Council of March 9, 1999, on radio equipment and
telecommunication terminal equipment (R&TTE) and the mutual recognition of
their conformity. The R&TTE directive repeals and replaces Directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station Equipment)
as of April 8, 2000.
Eu CountriEs intEndEd For usE
The ETSI version of this device is intended for home/ofce use in Austria, Belgium,
Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, the
Netherlands, Portugal, Spain, Sweden and the U.K., and is also authorized for use
in EFTA member states Iceland, Liechtenstein, Norway and Switzerland. (EU
countries not intended for use: none.)
gEnEral saFEty
This equipment is designed with the utmost care for the safety of those who install
and use it. However, special attention must be paid to the dangers of electric shock
and static electricity when working with electrical equipment. All guidelines of this
manual and of the computer manufacturer must, therefore, be followed at all times
to ensure the safe use of the equipment. Be sure to read and follow all warning Be sure to read and follow all warningBe sure to read and follow all warning
notices and instructions.
• Do not continue operating if you notice smoke or unusual odors or sounds.
Continued operation may result in electric shock or re. Immediately turn off
power and remove the power adapter from the outlet, then contact your vendor.
• Do not disassemble or modify the product in any way (unless described in the
instructions). Doing so may cause injury or electric shock.
• Make sure you use the power adapter supplied with the MFP server. Use of a
4
SAFETY & COMPLIANCE