Filter
Top Products
Chapter 2 — Configuring and Managing the SF51
14 SF51 Cordless Scanner User’s Guide
To configure the SF51 from your Intermec computer
Note: When you connect to an Intermec computer,
all SF51 settings that are common to the Intermec
computer’s internal scanner settings are changed to
the default settings of the internal scanner.
1 Establish a Bluetooth connection with your Intermec
computer. For help, see the procedure “To connect to an
Intermec computer” on page 17.
2 On your Intermec computer, start the Intermec Settings
application.
3 Select Data Collection > SF51 Scanner Bluetooth Address,
where Bluetooth Address is the Bluetooth address of your SF51.
4 Configure commands from the SF51 Scanner menu for your
SF51.
5 Select File > Save Settings. The SF51 is updated with the
new configuration command settings.
6 Close Intermec Settings.
Restoring Default Settings
You can restore the SF51 to its default settings by scanning the
Administrator Reset Factory Defaults command. For a list of the
default settings, see “Configuration Commands by Function” on
page 33.
Note: Using the Administrator Reset Factory
Defaults command resets all parameters. As a result,
you will lose Bluetooth communications.
To restore default settings
• Scan this bar code:
Administrator Reset Factory Defaults
\60\08\55\22