Filter
Top Products
36
Hotkey Beeper Control
The beeper (see Activate Beeper, page 26) can be hotkey toggled on and off. To toggle the
beeper, key in the following hotkey combination:
1. Invoke hotkey mode with the [Num Lock] + [-] or [Ctrl] + [F12] combination.
2. Press [B].
After you press [B], the beeper toggles on or off. The command line displays Beeper On or
Beeper Off for one second; then the message disappears and you automatically exit hotkey
mode.
Setting the Quick Hotkey
The Quick Hotkey (see HOTKEY, page 22) can be toggled between [Num Lock] + [-], and
[Ctrl] + [F12]. To toggle the Quick Hotkey:
1. Invoke hotkey mode with the [Num Lock] + [-] or [Ctrl] + [F12] combination.
2. Press [H].
After you press [H], the command line displays HOTKEY HAS BEEN CHANGED for one
second; then the message disappears and you automatically exit Hotkey mode.
Setting the OSD Hotkey
The OSD Hotkey (see OSD HOTKEY, page 20) can be toggled between [Scroll Lock], [Scroll
Lock] and [Ctrl], [Ctrl]. To toggle the OSD Hotkey, key in the following hotkey combination:
1. Invoke hotkey mode with the [Num Lock] + [-] or [Ctrl] + [F12] combination.
2. Press [T].
After you press [T], the command line displays HOTKEY HAS BEEN CHANGED for one
second; then the message disappears and you automatically exit Hotkey mode.
Setting the Port Operating System
A port’s operating system can be changed to match that of the computer attached to the
port. To change a port’s operating system, key in the following hotkey combination:
1. Invoke hotkey mode with the [Num Lock] + [-] or [Ctrl] + [F12] combination.
2. Key in [Function], which refers to one of the following keys: [F1] for Windows; [F2] for
Mac; [F3] for Sun. After pressing a function key you automatically exit Hotkey mode.
Restore the OSD Default Values
This administrator only hotkey restores the GCS1108/GCS1208 default values. See “Factory
Default Hotkeys and Settings” on page 40. To restore the default values, key in the following
hotkey combination:
1. Invoke hotkey mode with the [Num Lock] + [-] or [Ctrl] + [F12] combination.
2. Press [R].
3. Press [Enter].
After you press [Enter], the command line displays RESET TO DEFAULT SETTING for three
seconds; then the message disappears and you automatically exit Hotkey mode.