Filter
Top Products
DLA-G150HTE
1-4
No.51847
6
Controls and Features
Front Side / Top Surface / Right Side
1 Exhaust vents
Vents for cooling fans through which warm air comes out.
CAUTION
• Do not block the exhaust vents, or heat will build up inside,
possibly causing a fire. Also, do not touch the vents, or this
could give you a low-temperature burn.
2 Carrying handle
Raise this handle when carrying the projector.
CAUTIONS
• When carrying the projector, do not transmit shocks to it.
Also be careful to keep it balanced.
• Do not carry it while the light-source lamp is on or the
cooling fan is operating. This could cause personal injury.
3 AC IN (power input) terminal
This is the power input terminal where the supplied
power cord is connected. For details, refer to page 30.
4 Fuse holder
A fuse rated T6.3A H 250 V is installed. (Power source
protection)
To replace the fuse, refer to page 56.
CAUTION
• When replacing the fuse, use the same rating and type.
Otherwise, a fire may occur and/or the projector may be
damaged.
5 MAIN POWER switch
This is the main power switch. When it is turned on, the
projector goes into stand-by state, and the STAND BY
indicator on the control panel comes on. (Refer to
page 31.)
ON [ ]:The main power turns on.
OFF [ ]:The main power turns off.
6 Adjustable feet (for adjusting the height and
angle)
By extending the feet, the projector angle can be
adjusted up to +7°.
For details, refer to “Adjusting the Inclination of the
Projector” on page 16.
7 Lens
Projection lens, which is an electrically driven, approx.
1.5 × zoom lens. Before projection, remove the lens cap.
8 Lens cap
The cap has a string attached and the string is fixed to
the projector when shipped from the factory. It is
recommended that the cap be fitted on to prevent the
lens becoming dirty when the projector is not used.
9 Remote sensor
When operating with the remote control, aim it toward
this sensor. (Refer to page 20.)
L
A
M
P
TE
M
P
H
I
D
E
P
C
V
I
D
E
O
M
E
N
U
K
E
Y
S
T
O
N
E
P
R
E
S
E
T
E
X
I
T
E
N
T
E
R
O
P
E
R
A
T
E
9
7
5
4
3
2
8
6
1