Filter
Top Products
27
d Adjusting focus
To focus on nearer points, press the [FOCUS +] button
To focus on farther points, press the [FOCUS -] button
e Hiding the image temporarily
Press the [HIDE] button
● The displayed image will disappear.
● Press the [HIDE] button again the restore the image.
f Turning off the power
A Press the [OPERATE OFF] button for 1 second or more
● The [OPERATE] indicator turns off, the [STAND BY] indicator starts
blinking and this unit switches to the cool down mode. The cool down
mode will last for about 60 seconds to allow the temperature of the
light source to cool off. (A Page 15)
● This unit switches to the standby mode at the end of the cool down
mode.
B Pull out the power plug from the power outlet
ON
ENTER
OFF
CHP
TEST
MENU EXIT
LIGHT
OPERATE
HIDE
PRESET
ZOOM
T
W
FOCUS
TW
ZOOM
+
-
FOCUS
MENU EXIT
OPERATE
ON
OPERATE
OFF
HIDE
RS232C Rx
Tx
e
f -
A
e
d
f -
A
d
Indicator
NOTE:
The [OPERATE OFF] button will not work within approximately 1
minute after the light source has been turned on. Start operation
only after 1 minute’s time.
CAUTION:
Do not pull out the plug when the [STAND BY] indicator is blinking.
This may shorten the lamp life and cause a malfunction.
Precautions During Use
This unit makes use of a light source lamp that may reach a high
temperature during projection. Do not allow projection under the
following conditions. Doing so may cause fire or malfunction of
the unit.
● Projection with the unit laid on its sides
● Projection with the unit installed in an unreasonable angle
Avoid using this unit at an inclined angle. Doing so may cause
unevenness in the color or shorten the lamp life.
● Projection at a location that blocks the air inlets or exhaust vents
● Projection without removing the lens cap
TEMP
FAN
HIDE
Indicators on this unit
Light On
STAND BY
OPERATE
LAMP
Indicators on this unit
Blinking
Light off
ENGLISH
DLA-HD10_EN-FR.book Page 27 Thursday, November 10, 2005 12:54 PM