Filter
Top Products
Installing the Hardware
2-2 Part No. 6B4389June 1999Au-
Requirements
You need the following to install the NIC:
• Network cabling certified for 10 and 100 MB operation. The NIC
supports 10BaseT and 100BaseT cabling. Use category 5
unshielded twisted pair cabling for 100 MB operation.
• Phillips-head screwdriver
• If a BNC (10Base2) connection is required, purchase a BNC/
RJ45 transceiver or hub from your local dealer or distributor.
• If a connection from a single computer to a printer is required,
use a mini-hub and two network cables.
NOTE: You can use an Rx/Tx crossover cable as a direct
connection to a single computer without a hub. However,
an Rx/Tx crossover cable is a nonstandard cable that
may not be available from a local dealer. If you use an
Rx/Tx crossover cable, make sure that it is clearly labeled
so it is not confused with standard network cables for use
with network hubs or switches.
Installing the NIC in an 8660 Printer
1. Turn off, and unplug the 8660 printer.