Filter
Top Products
A-61662 October 2011 B-7
Maintenance
Replacing the ink cartridge 1. Turn off the scanner and power down the host PC.
2. Remove the front (or back) imprinter from the scanner. See the sec-
tions entitled, “Removing the front imprinter” or “Removing the back
imprinter” earlier in this appendix for instructions.
3. Remove the ink cartridge by grasping the ink cartridge holder and
pulling the tab on the ink cartridge out from the ink cartridge holder.
Ink cartridge disposal: Consult the Hewlett-Packard website for
recycling printing supplies or disposing of the ink cartridges
according to local regulations.
4. Remove the protective tape from the new ink cartridge.
5. Move the ink cartridge carriage to the center position.
6. Hold the ink cartridge holder and place the ink cartridge (bottom
end first) into the holder and snap it into place.
7. Reinstall the imprinter into the scanner.
8. Turn on the scanner and the PC.
9. Launch the Ngenuity Operator Utility and confirm the imprinter is
recognized.
Ink cartridge specifications
Center position
Subject Specification
Ink Cartridge Life Approximately 4,000,000 characters (standard font)
Approximately 2,000,000 characters (bold font)
Nozzles 12
Unusable Documents Plastic film or coated paper should not be used with the imprinter
Storage Environment Temperature: 32°F to 104°F (0°C to 40°C); Humidity: 10% to 80% RH
Operating Environment Temperature: 59°F to 86°F (15°C to 30°C); Humidity: 30% to 80% RH