Filter
Top Products
C-2 A-61662 October 2011
Using the straight pass-
through adapter
NOTE:If you are scanning exception documents, it is not necessary to
have the exit tray attached. Use the exit tray when you are
scanning many documents.
1. Remove the exit tray from the front of the scanner.
2. Install the exit tray matching the tabs on the exit tray with the slots
on the straight pass-through adapter and be sure that it is securely
in place.
3. Adjust the side guides and the end stop on the exit tray as desired
to meet your scanning needs.
NOTES:
• When you are not using the straight pass-through door to output your
documents, remove the exit tray, put it back in the front of the
scanner and close the straight pass-through door.
• Be sure the wire stand underneath the exit tray is folded down so it
rests evenly on the tabletop.
• When straight pass-through door is open, the Back Door status light
on the control panel will be lit.