Filter
Top Products
A-61124 March 1999 6-17
Permanently changing a group of parameters
A permanent change to a group of parameters is performed by
temporarily overriding a group of parameters and then sending a
scanner-unique Define Mode (JA) command to save the values to
a specified mode.**
The permanent parameter changes remain in effect until a SCSI
or power-on reset occurs.
The following table illustrates how the use of a scanner-unique JA
command can be used to permanently change a group of current
mode parameters:
RESULT
ACTION Compression Resolution
Scanner is in Mode 1 3* 200*
Host executes SCSI Send command
with 2FX300BX
2 300
Host executes SCSI Send command
with 4JA
Host executed SCSI Send command
with 4HA
2 300
Host executes SCSI Send command
with 1HA
3* 200*
Scanner is in Mode 1 3* 200*
Host executes SCSI Send command
with 2FX300BX4JA
2 300
Host executed SCSI Send command
with 4HA
2 300
Host executes SCSI Send command
with 1HA
3* 200*
* Parameter default value.
** The value(s) may be saved to the current mode or any of the
other modes.