Filter
Top Products
15
Replacing the Fuser
The fuser is located inside the
printer just behind the four image
drums.
1. Turn off the printer.
2. Wait approximately 10
minutes for the fuser to cool.
3. Open the top cover.
Caution!
The fuser becomes extremely hot
during normal operation. Do not
touch it.
4. Remove the fuser:
a. Move the two fuser release
levers toward the front of
the printer.
b. Hold the handle of the fuser
and lift it out of the printer.
If the fuser is still warm,
place it on a flat surface that
will not be damaged by
heat.
5. Remove the new fuser from its
packaging.
6. Hold the new fuser by the
handle. Make sure that the
retaining levers (a) are upright
and the locating lugs (b) are
facing you.
7. Install the fuser in the printer.
Make sure that the lugs are
aligned with the slots in the
printer.
8. Move the fuser release levers
toward the rear of the printer.
9. Close the top cover.
a
b
a
a
a
b
a
b
a