Filter
Top Products
A-61500 April 2009 3-9
Feeding documents
using multi-feed
detection
The scanner has three multi-feed detection sensors. When Multi-feed
detection is enabled, adjust the side guides so the documents fully
cover at least one sensor. If the document partially covers a sensor,
false multi-feeds may occur.
Automatic feeding To scan a batch of documents follow the guidelines for size, type,
quantity, etc., outlined in the “Document preparation” section.
For faster throughput, place documents into the elevator tray in
landscape orientation (longer side as the leading edge).
IMPORTANT: Staples and paper clips on documents may damage the
scanner. Remove all staples and paper clips before
scanning.
1. Align the leading edges of the stacked documents.
2. Position the stack of the documents, face up in the elevator tray so it
covers the paper present sensor.
NOTE: For Kodak i700 Series Scanners, Firmware Version 2.1.1
(or higher): When the i700 Series Scanner is powered-on
and paper is added to the elevator tray, the elevator will rise
to the “ready to feed” position. If you need to lower the
elevator tray, move the stack of documents slightly away
from the paper present sensor and the elevator tray will
return to the original Paper Source position (e.g., 250
Sheet, 500 Sheet, etc.) .
3. Adjust the elevator tray side guides.
4. Adjust the output tray position, if necessary.
5. Adjust the output tray end stop, if necessary.
Depending on how your scanner is set up, your documents will
automatically start scanning, or you may need to press the Start/
Resume button to begin scanning.