Filter
Top Products
bizhub C360/C280/C220 5-58
5.12 Communication Settings
5
5.12 Communication Settings
5.12.1 Line Settings (G3)
With this function, configure line settings for Fax TX.
Overseas TX
Faxes are sent to locations with poor communication conditions at a lower baud rate.
This function cannot be used together with the following functions.
- Polling TX
- Polling RX
- Bulletin board
ECM OFF
The Error Correction Mode (ECM) is turned off when sending data.
ECM is an error correction mode defined by ITU-T (International Telecommunication Union - Telecommuni-
cation Standardization Sector). Fax machines equipped with the ECM feature communicate with each other,
confirming that the data sent is free of errors. Thus, communication can be made free from disturbances due
to line noises, etc. If noises frequently occur, it may take a slightly long time to complete a communication
compared with ECM OFF. After sending has been ended, this machine automatically returns to ECM ON.
This function cannot be used together with the following functions.
- Polling RX
- Polling TX
- V.34 OFF
- Bulletin board registration
- Bulletin board polling reception
Reference
- This machine sends faxes in ECM ON unless ECM OFF is specified.
V.34 OFF
V34 is a communication mode used for super G3 fax communication. When the remote machine or this ma-
chine is connected to a telephone line via PBX, however, you may not establish a communication in the super
G3 mode depending on telephone line conditions.
In this case, it is recommended that you turn V34 off to send data. After sending has been completed, this
machine automatically returns to the V34 mode.
This function cannot be used together with the following functions.
- Polling RX
- Polling TX
- Bulletin board registration
- Bulletin board polling reception
- ECM OFF