Filter
Top Products
bizhub C360/C280/C220 9-10
9.2 One-Touch/User Box Registration
9
Reference
- To check a registered destination, select its registered name, and then press [Check Job Set.].
- To change the settings for a registered destination, select its registered name, and then press[Edit].
- To delete a registered destination, select its registered name, and then press [Delete].
Item Description
[No.] Press [No.], and then enter the registration number of the des-
tination between 1 and 2,000. Press [OK] without entering any
number to register the smallest number available.
[Name] Use the touch panel to enter the name to be registered in the
address book using up to 24 characters.
[Fax Number] Enter the fax number for the destination using the keypad up
to 38 digits.
• When the PBX connection is enabled and a call is made
from the internal line to the outside line, press [Pause] after
the outside line number such as "0" so that dialing is made
more surely. [P] is displayed on the screen.
• When the PBX connection is enabled, [Outside] is dis-
played on the screen. When you select it, an [E-] is dis-
played.
• If [Confirm Address (Register)] is ON, a screen for entering
the fax number again appears after you press [OK]. Enter
the fax number and then press [OK].
d Reference
For details on the Confirm Address function, refer
to page 10-21.
[Line Settings] Configure the line that is used to send faxes.
[Overseas TX] The transmission rate is set to a lower level when having a poor
communication.
[ECM OFF] Error Correction Mode (ECM) is cancelled to shorten the trans-
mission time.
ECM is an error correction mode defined by ITU-T (Internation-
al Telecommunication Union - Telecommunication Standardi-
zation Sector). Fax machines equipped with the ECM feature
communicate with each other, confirming that the data sent is
free of errors.
[V.34 OFF] V34 is a communication mode used for super G3 fax commu-
nication. When the remote machine or this machine is con-
nected to a telephone line via PBX, however, you may not
establish a communication in the super G3 mode depending
on telephone line conditions.
In this case, it is recommended that you turn V34 off to send
data. After sending has been completed, this machine auto-
matically returns to the V34 mode.
[Check Dest. &
Send]
The specified fax number is compared with the remote fax
number (CSI) and data is sent only when those fax numbers
match. If they do not match, the communication will fail; there-
fore preventing a sending error.
• To check the destination and send, the fax number of this
machine must be registered with the recipient's fax ma-
chine.
[Select Line] If two fax expansion kits are installed, you can select [Line 1]
or [Line 2] to send a fax. Specify the line used for sending fax-
es.
[Index] Select the index. For a frequently used destination, specify the
index characters and select [Favorites] at the same time. This
allows you to find it more easily.
[Icon] Select an icon.
• The selected icon is used for the image panel function that
is available when the optional function code "CAA" is ena-
bled.