Filter
Top Products
Chapter 1 Overview
1-5
●Hardware Configuration
Basic Configuration
Configuration of the print controller is as follows:
• Architecture: IBM Compatible PC System
• Processor: Intel Celeron 566 MHz
• Memory: 64 MB standard / 192 MB max. (Optional)
• Hard Drive: IDE compatible 2.0 GB min.
●Interface
Do not use the parallel port with the Ethernet interface. Otherwise, a system error may occur.
Parallel
Centronics (IEEE 1284)
Ethernet
100BaseTX and 10BaseT
The network interface card is used to connect to the Ethernet. This card is the internal
network interface card which supports multiple protocols on the Ethernet. This card
includes a CPU and flash memory with an upgradable program.
The network interface card supports the following network protocols.
• IPX/SPX (NetWare, Peer to Peer)
• TCP/IP (LPD/LPR, Peer to Peer)
• AppleTalk (EtherTalk)
For guidance in configuring the settings for networks, refer to "Network Setup" in your INSTRUCTION
MANUAL.
Do not use the parallel port with the Ethernet interface. Otherwise, a system errors will occur.
HOME