Filter
Top Products
Chapter 4 Control Panel Setup
4-20
●Interrupt / Reserve
The Interrupt mode can be used to interrupt the current printing operation to perform a copying job. The
Interrupt mode can be selected when the engine is receiving print data or when printing is already in
progress.
Under some conditions of printing or Finisher settings, the Interrupt mode cannot be used.
How to interrupt
1. Press the [INTERRUPT] key when the print job is in progress.
2. Place new original(s) on the platen glass or in the document feeder.
3. Press [START] key to start Interrupt Copying .
4. After copying is completed, press the [INTERRUPT] key again to enable the engine to
resume the interrupted print job.
If the [INTERRUPT] key is pressed while receiving the job data, Interrupt mode will become avail
-
able after the receiving is complete.
If the [INTERRUPT] key is pressed while printing is in progress, Interrupt mode will become avail
-
able after the current set of print job is completed.
Even without pressing the [INTERRUPT] key again, interrupted print job will resume automatically
on the following conditions:
• AUTORESET is activated and it reaches the set value.
• When the interrupt release timer which works 1 minute after INTERRUPT job is complete, is
activated.
The interrupt release timer works when AUTORESET is not activated
How to use Reserve function
1. Touch the [FREE] folder to set the conditions for a copying job.
2. This copying job will be performed after the print job in progress is completed.
HOME