Filter
Top Products
15
four-measure sample to create a one-mea-
sure loop.
1. The SHIFT button will light and the
specified SAMPLE BANK button will
blink green.
2. All eight PROGRAM MEMORY buttons
will light (by default).
By pressing the corresponding button you
can turn on or off each sample slice.
Resampling
By resampling, you can create a sample
that combines multiple existing samples,
or create a new sample from an existing
sample processed by an effect. You can
resample to create both loop and one-shot
samples. Remember that with resampling,
the output of the KP3 is being recorded, so
all of the effects created using the touch
pad will be recorded as part of the sample
data.
1. Hold down the SHIFT button and press
the SAMPLING button.
2. The SAMPLE BANK buttons will blink
orange, and the KP3 will be in the record-
ready mode.
3. From here, follow the same instructions
for loop and one shot sampling in the pre-
vious section.
NOTE When you press a SAMPLE BANK button,
the playback of the data assigned to that BANK but-
ton will stop and will be overwritten.
Function settings
By holding down the SHIFT button and
press one of the PROGRAM MEMORY 1–
8 buttons you can execute various func-
tions such as formatting a card or saving/
loading samples. Use the following proce-
dure to access any of the Function settings
and to edit their various parameters.
1. Hold down the SHIFT button and press
one of the PROGRAM MEMORY buttons
1–8.
2. Use the PROGRAM/BPM knob to select
a sub-parameter.
3. Press the PROGRAM/BPM knob to
view the value options for that parameter.
4. Use the PROGRAM/BPM knob to select
a value.
5. Press the TAP/RANGE button (lit or-
ange) to return to the parameter list. Re-
peat steps 2–5 to edit additional param-
eters.
6. At this point, you can either press the
WRITE button (blinking) to save the
changes you have made, or you can press
the SHIFT button to exit without saving.
NOTE While the TAP/RANGE button is lit or-
ange, you can press the TAP/RANGE button to re-
turn to the preceding page.
About each function
[1] CARD
Info: Displays the total capacity of the
SD card.
Free: Displays the remaining capacity of
the SD card.
Form: Formats the SD card.
[2] LOAD
Loads data from the SD card into the KP3.
[3] SAVE
Saves data from the KP3 to the SD card.
[4] MIDI FILTER
Specifies the MIDI clock setting and MIDI
message filtering.
[5] MESSAGE
Specifies the channel on which MIDI mes-
sages will be transmitted/received, and