Filter
Top Products
Controlling Kramer Machines via Ethernet using the FC-1ETHN
KRAMER ELECTRONICS, LTD.
10
6.3.2 Master Routing Mode
In the Master Routing Mode, the FC-1ETHN does not wait for the remote
station to send the data first, and routes the data in the destination device
direction as soon as there is data to be sent. The data is always sent to a
specific destination (as defined by the Destination IP address and Destination
Data Port Number Settings of the FC-1ETHN). Also, the FC-1ETHN only
accepts the data sent from the remote station whose IP address matches the
one set in the Destination IP address. The FC-1ETHN will discard the data
sent from any other IP. See the example illustrated in Figure 5:
Figure 5: Connecting the FC-1ETHN in the Master Routing Mode
7 Controlling Kramer Machines via Ethernet using the FC-1ETHN
You can use your FC-1ETHN to control a Kramer machine from computers
that connect to a LAN
1
(see section 7.1) or via a controller
1
(see section 7.2).
1 As well as via an Internet connection