Filter
Top Products
Parallel Interface
C-2
Parallel Interface
Parallel interface communication modes
The printer features the fast data transmission mode on the parallel interface. The parallel interface
mode can be changed by using the PRESCRIBE FRPO O0 command. See the
Programming manual
(in the Kyocera Digital Library CD-ROM) for details.
Note______________________________________________________________________
Use a parallel printer cable that complies with the IEEE1284 standards.
Nibble (high)
(FRPO O0, 5; [default])
High speed data communication is used in compliance with the IEEE 1284 standard. Ordinarily, you
should leave this setting unchanged.
Auto
(FRPO O0, 70;)
The printer automatically changes its communication mode to the one the host computer is currently
using.
Normal
(FRPO O0, 0;)
The printer uses the communication method described by the normal definitions of the Centronics
interface.
High-speed
(FRPO O0, 1;)
This mode enables faster data reception from the host computer by the normal definitions of the
Centronics interface..