Filter
Top Products
Switching the Fusing Temperature
When you make a copy on translucent paper or transparent film, switch the
fusing unit temperature to stabilize toner fusing.
S If you make a copy in the condition unsuitable for copy paper, the copy might
be creased or a part of the image might not be copied.
S Turn on the "HIGH" indicator for translucent paper and "LOW" for transpar-
ent film. The time required for changing the fusing temperature for the
standard paper to that for the "HIGH" or "LOW" setting is as follows. This
time might vary depending on the copier condition.
• HIGH - About 3 minutes
• LOW - About 5 minutes
S The fusing temperature is switched automatically when you change the
paper type. When you want to make a copy immediately, press the Fusing
Temperature key to return the fusing temperature to the one set before
switching.
S When you specify a different width of roll paper, the fusing temperature might
be switched automatically.
S When you set the fusing temperature to "HIGH", the paper curls easily.
Uncurl such copies before stocking them.
1
Press the Fusing Temperature
key to turn on the "HIGH" or
"LOW" indicator.
The "Wait" indicator goes on and
either the "HIGH" or "LOW"
indicator is lit.
✏ When the "Wait" indicator
goes off and the "Ready"
indiator goes on, the copier
enters the ready condition.
BASIC
COPYING 7